| Hurricane protection without replacing
your existing garage door A Secure DoorŽ vertical brace is pictured below on the inside of a typical 70 mph non-wind loaded steel door. |
|
![]() |
|
| Secure DoorŽ
is designed for do-it-yourself installation by most homeowners.
Set up and installation requires an electric drill, a ˝" masonry
bit, a 5/16 inch socket driver, a crescent or socket wrench, a
hammer, scissors or utility knife, and a single blade
screwdriver. The set-up and installation of the first brace
typically can be completed in about 45 minutes with additional
braces taking less time. Once the initial installation is complete, Secure DoorŽ is removed until needed. When not in use, only the top bracket (attached to the wall above the garage door) and the bolts for the floor anchor remain permanently in place. The floor anchor bolts fit flush and inconspicuously out of the way on the garage floor. After the initial installation is complete, each Secure DoorŽ brace can be put in place should a hurricane threaten (and subsequently taken down) in less than three minutes.
|
|